Clutch Lever Bushing
Couldn't load pickup availability
This is a clutch lever bushing. This OEM Honda bushing is designed to replace the original bushing found in all Goldwing GL1200's, GL1500's, GL1800's and F6B's from 1984-2017. This brass bushing is designed to wear and when it does, it can prevent the microswitch on the master cylinder from activating. This is the switch that allows the bike to start in gear with the lever pulled in. 22885-MB0-006
Item: H22885-MB0-006 Honda
Customer Reviews
Very easy to order fast service OEM part very good satisfied
Easy to change and fixed my cruise control from dropping!!
I was amazed at the effect the clutch had on smoothness from replacing the old worn out bushing. I would think that the hole with the pin goes into... Was probably worn deeper than it should have been. So when I installed the new one I could tell that it was engaging the clutch back to the full travel that I needed to be and that has resulted in much smoother shifting! Something that every owner should look at and inspect. Take a look at the photo I attached, if you take your clutch lever off and your bushing looks like this, it needs replaced!
Quick , easy and on time !
It was simple to find the part I needed and order it. The part arrived early!
